| Display Elements: |
Red LED to indicate KNX Normal-/Addressing Mode
Green PWR-LED to signal device readiness (blinks when in normal
operation mode)
Red ERR-LED to signal fault status
LC-Display, 2 lines with 12 characters each with menu for commissioning
and setting of parameters.
|
| User Elements: |
Programming Button to toggle between normal
and addressing mode
3 buttons (SCROLL, Prg/Set, ESC) on display front to commission the
device and set parameters |
| Connectors: |
KNX bus connector
Mains Connector: screw connector 3x 1,5mm² single or threaded
core
DALI-Bus: screw connector 2x 1,5mm² single or threaded core
Binary input: screw connector 2x 1,5mm² single or threaded
core busline: bus connector KNX
|
| Inputs: |
2 x passive binary input for connection of conventional
pushbutton or movement sensor 9-32 VDC or 8-26 VAC, max wire length
15m |
| DALI Bus: |
Connection of up to 64 ECGs complying to IEC 60926
DALI-Voltage 18-21 VDC, short circuit proof
It is not allowed to use other control devices (DALI-Master devices)
within the same line. |
| Bus Coupler: |
integrated in device, connection with standard bus connector |
| Dimensions: |
35mm DIN rail mounting 6 units wide:
106mm x 55mm x 86mm |
| Weight: |
200 g |
| Casing: |
LEXAN UL-94-V0 |
| Environmental Conditions: |
EN 50090-2-2 |
| |
Operation: 0°C to +45°C
Storage: -25°C to +70°C |
| Rel. Humidity: |
non condensing: 5 % to 93 % |
| Power Supply: |
Mains Connector for 110 to 240 VAC, 50 to 60Hz, max. 0,1A
KNX Bus SELV 24 VDC |
| Protection type: |
IP20 according to EN 60529, Din VDE 0470 |
| Class: |
I according to IEC 1140 |
| Pollution Class: |
2 |
| Overvoltage Category: |
III |
| EMC: |
complies with EN 50081-1, EN 50082-2, EN
50090-2-2 |
| CE-Signage |
According to EMC-Guidelines (Residential
and commercial buildings), Low Voltage guidelines |
| Certification |
EIB/KNX registered |
